How to use the heating bracket

The heater bracket is used to fix and support the heater, ensuring that it is safely and stably installed on the wall. Here are the basic instructions for using the heater bracket:

1. Determine the location:
- Determine the best location for the heater installation based on the size and weight of the heater and the indoor layout.

2. Measure and mark:
- Use a tape measure to measure the size of the heater, determine the location where the bracket needs to be fixed on the wall, and mark the wall.

3. Check the wall:
- Check whether the wall is strong enough to support the weight of the heater. If it is a hollow brick wall or a gypsum board wall, special anchors may be required.

4. Drill holes:
- Drill holes at the marked locations, and the depth and diameter of the holes should match the bracket's expansion screws or wall plugs.

5. Install expansion screws or wall plugs:
- Place the expansion screws or wall plugs in the drilled holes and tap them gently with a hammer until they are secure.

6. Fix the bracket:
- Align the heater bracket with the expansion screws or wall plugs on the wall, tighten the screws with a screwdriver or wrench to fix the bracket.

7. Adjust the level:
- Use a level to check whether the bracket is level and make fine adjustments if necessary.

8. Install the heating equipment:
- Place the heating equipment on the bracket. Depending on the design of the equipment and the bracket, you may need to fix the heating equipment to the bracket with screws or other fixings.

9. Check stability:
- Apply appropriate pressure on the heating equipment and check the stability of the bracket and the heating equipment to ensure that there is no looseness.

10. Connect pipes and power supply:
- If it is a water heating heater, connect the inlet and outlet pipes; if it is an electric heating heater, connect the power cord.

11. Test the heating equipment:
- Turn on the heating equipment and check whether it is working properly and confirm that there is no water leakage or electric leakage.

12. Complete the installation:
- After confirming that everything is normal, complete the installation and clean up the work area.

Please note that different types and brands of heating equipment may require different installation methods. Always refer to the product manual or consult a professional for installation. Safety first, if you are not sure how to operate, it is best to ask a professional to install it.